Top new questions this week:
|
|
What could be going wrong here? I have never seen this sort of printing problem before or I am just not recognizing it. It most definately is coming from the filament because I have tried switching …
|
|
I recently had some filament get stuck in the Bowden tube so much so that I had to remove it from the stock Creality heatsink on my Ender 3 v2. As I was taking the tube out of the heatsink I noticed …
|
|
I’m experiencing an issue with the auto homing where the Z-axis will ignore the endstop when I use the auto home button in Pronterface. Strangely, homing the axes individually I don’t seem to have any …
|
|
I’m thinking about trying to use a 12 V power supply for the board and 24 V for the hotend and heatbed triggered by some MOSFETs modules like this Power Expansion Board Heating Controller MOSFET High …
|
|
I’m using PrusaSlicer 2.5.0 and printing the sliced G-code on a Creality CR-6 SE via a USB-connected OctoPrint/OctoPi. As you can see, the slicer sets the temperature by G-code commands in two steps (…
|
Greatest hits from previous weeks:
|
|
I just received my new Creality Ender 3. I was going through and checking/adjusting everything for alignment, and I noticed that when you “auto home” the print head, the nozzle stops off the …
|
|
I have just upgraded my board to TH3D’s EZBoard Lite with their Unified Firmware (U2.R1.15) and whilst dialling in all the setting I have found that using the BlTouch each time to be frustrating …
|
|
I have seen mechanical (micro switch), optical and magnetic(magnet + hall sensor) end stops. Are there any differences in how exact they switch at the right location? If so which are the most …
|
|
I’ve already asked this question somewhere else but unfortunately I had little luck. So… my Ender 3 Pro extruder just started skipping steps, as in the gears (and the gear pinion) will rotate but …
|
|
Whenever a 3D printer that uses linear rails is announced (case in point: the cetus), the Internet (well… at least that corner of it dealing with 3D printing) gets abuzz with excitement. I …
|
|
I’m having a lot of difficulty removing support material without damaging the print. Are there any tips/tricks to doing this or is it just a case of sanding, cutting, chopping and then cleaning it up …
|
|
In setting up a probe for automatic bed leveling, the limits of the probing area must be entered in the firmware of a 3D printer. When using a sensor, how do you define the bed limits for the sensor …
|
