Top new questions this week:
|
|
Setup: Anycubic Kobra Neo (Firmware v1.3.3), Cura 5.2.1 I recently bought an Anycubic Kobra Neo. It works but has issues with auto bed leveling. Specifically, auto bed leveling does not compensate for …
|
|
Currently my 3D printer starts all projects from the lower left corner of the heatbed. I want to change the default setting to make the center of the heatbed the default position. However, I have not …
|
|
I’m printing a keychain. In fact, I’ll soon be printing a LOT of these keychains (they’ll be available to everyone at a school). After a couple test prints everything looks good… except for one …
|
Greatest hits from previous weeks:
|
|
A few weeks ago I got a thermal runaway message on my modded Ender 3 during a print, and I have not been able to get it working since then! I have tried fixing and replacing everything, and I still …
|
|
I have been working with our SLA printer (Facture Draken) for a couple weeks now printing in makerjuice waxcast. . I have had some successful prints, but the majority (80%) end up as pancakes stuck …
|
|
Occasionally, while printing, my y axis will slip and the layer will, from that point forward, be shifted, ruining the print. What might be the causes of an axis slipping? I have tried cooling the …
|
|
I was having an issue with flat sheets raising up during initial layers. I had my bed at 80 °C and kept raising it thinking it was an issue with cold. After reducing the temperature to 50 °C the …
|
|
Whenever a 3D printer that uses linear rails is announced (case in point: the cetus), the Internet (well… at least that corner of it dealing with 3D printing) gets abuzz with excitement. I …
|
|
I bought an Ender 3 two days ago and assembled it today. I think I did it properly, tested the movement of all axes which works for all axes. Then I performed the calibration as described in the …
|
|
I recently installed an original BLTouch V3 on my Ender 3 pro and ever since I can’t seem to get a decent print. My first layers are horrible. The install wasn’t so bad, I really thought it would be …
|
