Top new questions this week:
|
|
I’m having this weird issue; for some weird reason, the infill pattern starts separating from the walls and over time, the print becomes a mess. As it separates, it starts to curve, and you get this …
|
Greatest hits from previous weeks:
|
|
Is there a specific name for that problem? What causes this, and is there a way how to solve it? Printed with PLA, 2 mm nozzle diameter, 0.2 mm layer height, 20-60 mm/s, 200 °C …
|
|
I would like to understand the differences between rafts, skirts and brims. They appear in the software which I’m using to edit my 3D objects. Can anybody elaborate what are these and what are the …
|
|
Whenever a 3D printer that uses linear rails is announced (case in point: the cetus), the Internet (well… at least that corner of it dealing with 3D printing) gets abuzz with excitement. I …
|
|
I’ve had issues with my hot end and decided to replace the whole assembly with this. After the replacement, my printer started reading about 135/185 °C for the hot end and bed are both at …
|
|
I´ve have read an article to change different pattern depending on amount of layers, but my question is if is possible to have different infill in the same part? For example: Base: has the infill of …
|
|
I am going through some of the basics about one of the 3D printing techniques – Selective Laser Sintering, and I am confused between the above mentioned parameters – scan distance and hatch distance. …
|
|
I have what I thought would be a simple question. I don’t have an auto leveling probe, I do my leveling manually with 4 screws and a piece of paper (I measured the thickness to 0.1 mm). For the …
|
