Top new questions this week:
|
|
Alright, a few assumptions about the printer. It can handle the momentum of the nozzle moving so fast. I have good enough bed adhesion to do this. The nozzle can handle the amount of filament going …
|
|
Issue: I realized that the filament extrusion always stops at the same spot for a couple seconds then starts back, I know it’s the printer and not the filament, I can see the gear literally stop for a …
|
|
I use “Flashprint 5” as a 3D print pre-processing software. I want to have a 0-degree raster angle for all its layers (100 % infill density), in the attached object below. But what I found …
|
|
I’m trying to model a “mushroom-like” object. I created the stem and the top part and shelled them to a body with 5mm walls. I also need to split the top part into two parts which I will …
|
|
I have just calibrated my extruder and everything is ok. When I extrude 100Â mm of filament, everything is correct, but when I attach the Bowden tube to the nozzle, the length of filament that is …
|
|
I created a box in Blender and exported that into an stl and it seems to be failing to render the correct walls. The box looks like this: But when I open it in Cura, it looks like this: Is there …
|
|
I seem to be having trouble managing the printer for slicing process in Ultimaker Cura. I use Flashforge Guider 3 Plus printer and added it to Ultimaker Cura manually (there was no Guider 3 Plus …
|
Greatest hits from previous weeks:
|
|
I need to set a Z offset for the Flying bear P902. I calculated the offset (-2.98). But, every time when I try to input this using the LCD screen of my 3D printer, the value jumps to either -2.99 or -…
|
|
I have what I thought would be a simple question. I don’t have an auto leveling probe, I do my leveling manually with 4 screws and a piece of paper (I measured the thickness to 0.1 mm). For the …
|
|
I am going through some of the basics about one of the 3D printing techniques – Selective Laser Sintering, and I am confused between the above mentioned parameters – scan distance and hatch distance. …
|
|
Anyone have any idea how much power it takes to run a Creality Ender 3 3D printer every day for several hours at a time? Like what does it eat up per hour? A rough estimate of power use per hour would …
|
|
I’ve been playing around with PETG for the first time, and everything seemingly worked right just from the start – clean prints, no stringing, no bed adhesion problems, no warping or dimensional …
|
|
I’m having a lot of trouble printing polypropylene right now, and I think it may have to do with the conditions. I’m using a very thin coat of ABS on the base plate (just as you would do when printing …
|
|
Like many people, I have burnt the pins in the micro-controller connected to the E0 motor – the E0 motor is not working anymore and I need to print tomorrow! I need to control the extruder motor with …
|
Can you answer this question?
|
|
I have enabled UBL in Marlin firmware for my Ender 3 Pro and generated a mesh which probed the whole bed normally as expected. However when I use the menu option to Validate Mesh, the whole test …
|
