Top new questions this week:
|
|
I’m trying to figure out how to get my BTT Smart Filament sensor to work with my printer. I have looked at Getting BTT filament sensor to work and have tried almost everything they did. Relevant Specs …
|
|
Is it safe to give a 3D printed toy (printed using food-safe filaments) to a toddler? Are there any recommendations/studies on what is considered safe?
|
Greatest hits from previous weeks:
|
|
Using a 3D pen I printed a small box. However, I was doing it on plain paper and of course the paper didn’t come off the plastic very well. It didn’t matter for that specific case, but if I want to …
|
|
When printing cube.gcode using Pronterface I get: Print started at: 23:07:31 After 8 seconds I get: …
|
|
I’m having a lot of trouble printing polypropylene right now, and I think it may have to do with the conditions. I’m using a very thin coat of ABS on the base plate (just as you would do when printing …
|
|
My printed objects have horizontal holes in them (as seen I the picture below): This doesn’t only look bad it also makes the object break at the seems. Looking carefully at the printing process I …
|
|
In setting up a probe for automatic bed leveling, the limits of the probing area must be entered in the firmware of a 3D printer. When using a sensor, how do you define the bed limits for the sensor …
|
|
Various methods to scan the top surface exist to improve the bed adhesion to prevent prints to come loose from the bed during printing: e.g. BLTouch and clones or inductive and capacitive sensors/…
|
|
I made two updates to my Ender 3 Pro: Silent Mainboard and BLTouch. My printer head is way out of sync now. After I Auto Home, it moves along the X-axis to the left, hits the stop switch & moves …
|
Can you answer this question?
|
|
I’m currently printing several cases for electronics, one for a Raspberry Pi 4 and two for smaller electronics. These cases will be attached to a drone which might be exposed to rain. The cases itself …
|
