Top new questions this week:
|
|
Well, I know what my critical error was, I was in a hurry and set a print running before leaving it unattended for about 8 hours; came home to a great enormous disaster. What on earth happened? …
|
|
My Dremel 3D45 stopped the extrusion. I removed the nozzle thinking about it was clogged. But still it didn’t solve. Also the nozzle was harder to remove than usual. So I removed the bottom cover and …
|
|
Recently my hotend extruder got stripped out so I bought a new one and went to replace it, after finishing, my screen wouldn’t turn on and it is no longer connecting to my PC. The filament sensors …
|
|
How to use organic supports in PrusaSlicer? I heard that it is possible, but I can’t find this option in PrusaSlicer or Cura.
|
|
I’ve recently obtained a Creality Ender-3 V2 3D printer and have tried setting it up. With it came 2 modifications (CR Touch auto bed leveling kit and dual Z-axis kit). The installation of the dual Z-…
|
|
So I’m kind of a newbie to 3D printing. I got my Ender 3 about 3 days ago and some PETG filament to accompany it. These are the slicer settings: Hotend: 235 °C Initial bed temperature: 80 °C Bed …
|
|
I’ve just updated my Ender 3 to 32 bit version 4.2.7 and the Z stepper is reversed. Ender 3 32 bit 4.2.7 board Marlin Bugfix 2.0.x
|
Greatest hits from previous weeks:
|
|
When I run prints on my Creality CR-10S Pro 3D printer (using Ultimaker Cura as slicer), I set the heated bed to around 70 °C for PETG. after the first few layers, the heated bed set point …
|
|
I’m having issues with ripples on the first layer of big flat prints. The initial corner of a big flat print is fine, but then ripples begin to form as shown in the screenshot. I’m just a newbie, so …
|
|
I’m having a lot of trouble printing polypropylene right now, and I think it may have to do with the conditions. I’m using a very thin coat of ABS on the base plate (just as you would do when printing …
|
|
I have an Ender 3 that I have been pretty happy with so far, however it recently started an odd behavior and I can’t figure out what’s causing it. What happens is that the first ~3 mm of the …
|
|
The backstory: I’m installing a pigeon net in my home. Because of the shape of the opening I’m installing the net in and the material on the sides it’s difficult to anchor the net using the normal …
|
|
Question What is PLA+? How is it different than PLA? I’m looking for science, composition, formula, safety concerns (or lack thereof), etc. Background I picked up a roll of PLA+ at Microcenter (…
|
|
I have seen mechanical (micro switch), optical and magnetic(magnet + hall sensor) end stops. Are there any differences in how exact they switch at the right location? If so which are the most …
|
Can you answer these questions?
|
|
We have the problem that our machine automatically performs a Z-homing when our software connects to the Arduino, but only the Z-axis. We would like to disable it, but could not find the line in …
|
|
Just came to the 3D printing world and after installing Marlin 2.1.2 firmware in my Ender 3, which took a while and was finally completed following this tutorial: I …
|
