Top new questions this week:
|
|
I am using a Cobra Max to print PLA. I am trying to print a computer / tablet case. There are some “defects” in it which look like the print head dragged something. I have used a …
|
Greatest hits from previous weeks:
|
|
I have an Ender 3 that I have been pretty happy with so far, however it recently started an odd behavior and I can’t figure out what’s causing it. What happens is that the first ~3 mm of the …
|
|
I have just upgraded my board to TH3D’s EZBoard Lite with their Unified Firmware (U2.R1.15) and whilst dialling in all the setting I have found that using the BlTouch each time to be frustrating …
|
|
I have a (HIC) version of the Prusa i3. I have recently installed the E3D v6 hotend and titan extruder. After fixing some other issues, I noticed that there is no filament being extruded. In addition, …
|
|
The backstory: I’m installing a pigeon net in my home. Because of the shape of the opening I’m installing the net in and the material on the sides it’s difficult to anchor the net using the normal …
|
|
How does Z offset (M851) work with an auto leveling sensor? Does it add the Z offset to the offset of the G29 mesh? or the …
|
|
Is there a way to change the direction a motor goes with G-code instead of reconfiguring Marlin firmware?
|
|
Using a 3D pen I printed a small box. However, I was doing it on plain paper and of course the paper didn’t come off the plastic very well. It didn’t matter for that specific case, but if I want to …
|
