Greatest hits from previous weeks:
|
|
I bought an Ender 3 recently and it has the 4.2.2 Creality board. Then I bought a BLTouch to upgrade it with bed leveling. It turns out that the BLTouch now comes with a standard 5-pin connector …
|
|
I have what I thought would be a simple question. I don’t have an auto leveling probe, I do my leveling manually with 4 screws and a piece of paper (I measured the thickness to 0.1 mm). For the …
|
|
I printed a model and now I can’t remove it. I have been chiselling away with a putty knife and made little or no progress. I even heated the bed up to 70 °C. That really didn’t seem to …
|
|
I’m printing on an Ender 5 with the default flex/magnetic build surface. I read that PLA and PETG may sometimes be printed without any bed heating at all and also that bed heating is the main …
|
|
Ok, I did it, I ordered myself an Ender-3, a genuine 24V e3D hotend, inductive sensor and some better tubing/clamps to cope with the problem the CR10/Ender line has occasionally. But now I need to …
|
|
I have been working with our SLA printer (Facture Draken) for a couple weeks now printing in makerjuice waxcast. . I have had some successful prints, but the majority (80%) end up as pancakes stuck …
|
|
I’ve just received my Ender 3v2 and tried multiple SD cards, all have been formatted to FAT32 with no luck. Under the Print selection, all I get is the back button. I looked and I have the V4.2.2 and …
|
