Top new questions this week:
|
|
This line has started to appear on my prints. I’ve tried to revert the settings I’ve changed back to my original settings but the line is still there. The previous prints didn’t have this line as far …
|
|
So I’ve followed the wonderful tutorial here and managed to modify the Anycubic firmware to include more mesh points to probe for (I’ve set it to have a 15×15 grid because I’m printing a large scale …
|
|
How do I view the results from the BLTouch probing on my Ender 3? I have set up all the firmware and installed the BLTouch fine and it works as expected. But how am I able to see the results of the <...
|
|
I’m producing a series of brackets to allow a laser cutter to be reliably positioned on a waste board\spoil board in that has a measurement grid on it, and to allow a honeycomb bed to be reliably …
|
|
I am making my own printer. I used Repetier as firmware, made all cable connections, and installed the software. The screen came on and I connected it to the computer at the right frequency, but the …
|
|
I wanted to upgrade my Ender 5 plus to a silent board as it makes a lot of noise. So I chose the BTT SKR 3 EZ board and started to configure it. However, in the Marlin configuration, there was a …
|
Greatest hits from previous weeks:
|
|
Question What is PLA+? How is it different than PLA? I’m looking for science, composition, formula, safety concerns (or lack thereof), etc. Background I picked up a roll of PLA+ at Microcenter (…
|
|
Occasionally, while printing, my y axis will slip and the layer will, from that point forward, be shifted, ruining the print. What might be the causes of an axis slipping? I have tried cooling the …
|
|
What are the differences, and pros & cons, between 3D printers with varying layouts for moving head vs. moving build plate? Example layouts would include: X Head; YZ Bed; XY Head; Z Bed; …
|
|
On the reprap wiki it says using Znnn it sets a new axis position. But then it says “No physical motion will occur”. What would the line G92 E0 be used …
|
|
I’ve already asked this question somewhere else but unfortunately I had little luck. So… my Ender 3 Pro extruder just started skipping steps, as in the gears (and the gear pinion) will rotate but …
|
|
The print is very solid except for the 4 walls. From the top, I can slide a paper down to the bottom. This is ONLY between the walls, the rest of the print is solid. The filament is PLA 1.75 mm. …
|
|
I bought an Ender 3 recently and it has the 4.2.2 Creality board. Then I bought a BLTouch to upgrade it with bed leveling. It turns out that the BLTouch now comes with a standard 5-pin connector …
|
Can you answer this question?
|
|
I recently run into some problems with my FEP on my Anycubic Mono X, but not in terms of failing off the prints, but rather in the really short lifespan of the sheet. It frequently wears out and …
|
