Top new questions this week:
|
|
I just finished assembling my Ender 3 Pro and am having trouble with bed leveling. The extruder doesn’t even come close to the bed, the z-limit stops the nozzle about 3-4 mm away. The leveling …
|
|
I bought a very famed filament dryer (won’t mention the brand) which turned bad on me as I got a failed one; it got exceedingly hot (uneven 60-68 °C) and deformed an almost full PLA spool. Aside from …
|
|
I’m looking for a tool to modify STL files to make changes, before printing it. I know that it exists, but I don’t know the name of the software. For example, I have a STL file for a ball and I want …
|
|
I started playing with OctoPrint and I already have it configured for external access and management, using OctoEverywhere. I would like it to be an easy to use printer, because it is shared between …
|
|
Update: must have been something with the gcode, or how I was slicing it. Tried printing from the files that were already loaded on the sd card when I got it, and it came out much better. I then …
|
|
I designed a very simple boat in Tinkercad and then I printed it. No problem, but I wanted it a bit wider. So I made it wider in Tinkercad and printed it again. This second version has a crack in the …
|
|
I reinstalled Klipper with kiauh due to other issues I had. The folder klipper_config is still filled with all important config files and all G-code data is there …
|
Greatest hits from previous weeks:
|
|
I just installed my (v3) BLTouch with a vanilla version of Marlin (1.1.9) on my Ender 3 and everything seems to work fine (including auto home) except the probing. It repeatedly does the first three …
|
|
I’m having a lot of trouble printing polypropylene right now, and I think it may have to do with the conditions. I’m using a very thin coat of ABS on the base plate (just as you would do when printing …
|
|
I have an Ender 3 that I have been pretty happy with so far, however it recently started an odd behavior and I can’t figure out what’s causing it. What happens is that the first ~3 mm of the …
|
|
Where is the correct Marlin firmware file and location to add code that I want to shop up in the LCD menu of my printer, and then execute the function I write when the button is pressed? For example …
|
|
When printing cube.gcode using Pronterface I get: Print started at: 23:07:31 After 8 seconds I get: …
|
|
I recently became curious about the Line Width setting in Cura and why one might change it if they aren’t using different size nozzle. Since I’ve gotten my Ender 3, I’ve always kept the line width …
|
|
I am going through some of the basics about one of the 3D printing techniques – Selective Laser Sintering, and I am confused between the above mentioned parameters – scan distance and hatch distance. …
|
Can you answer these questions?
|
|
I recently purchased an MKS Robin wifi module for my spouse’s FLSUN Super Racer after noticing that the printer runs on an MKS Robin Nano V3.1 board. Immediately after installing the chip, I saw it …
|
|
I have been able to print for almost a year, then it began to fail. When I select Auto level from the LCD Screen, the print head moves to the front left, hovers the probe in the air, which causes the …
|
